WELCOME TO

Mercedes Independent Specialist Hull

 

 

 

Hands Free Mobile Phone Solutions

Now Available!

 

 

PLEASE NOTE: schedules are adjusted according to vehicle requirements and manufacturers' guidance.

 

 

A – Service

 

B - Service

Interim

 

 

Complete initial checks

ü

ü

Drain and replace engine oil (please note special/low ash oils subject to additional charge)

ü

ü

Replace oil filter

ü

ü

Check for engine oil leaks

ü

ü

Check and top up clutch fluid

ü

ü

Check and top up brake fluid

ü

ü

Check coolant/antifreeze and top up

ü

ü

Check gearbox oil (where applicable)

ü

ü

Check axle oil (where applicable)

ü

ü

Check automatic transmission fluids (where applicable)

ü

ü

Check steering and suspension components for wear

ü

ü

Check steering rack gaiters

ü

ü

Check fan/alternator belt and adjust tension if necessary

ü

ü

Check auxiliary drive belts for condition and tension (adjust if required)

ü

ü

Check power steering and top up reservoir where applicable

ü

ü

Check for correct clutch operation

ü

ü

Check propshaft, drive shaft and joints for operation and wear

ü

ü

Check drive shaft gaiters for play and leaks

ü

ü

Check brake pads for wear or damage

ü

ü

Check calipers for wear and leaks

ü

ü

Check brake shoes for wear

ü

ü

Check wheel cylinders for wear and leaks

ü

ü

Check shock absorbers for operation and performance

ü

ü

Visual check over of brake hydraulic system, pipes and hoses for wear and leaks

ü

ü

Visually inspect condition of fuel lines

ü

ü

Inspect exhaust fixings and check leaks and noise

ü

ü

Check handbrake for operation and travel

ü

ü

Check security of hand brake linkages and lubricate if required

ü

ü

Check operation of headlights, indicators and other exterior lights

ü

ü

Check vehicle horn

ü

ü

Check ABS warning lights

ü

ü

Check heater plug indicator (diesel models)

ü

ü

Test battery and check levels and fixings

ü

ü

Check windscreen wipers (and rear wiper if applicable)

ü

ü

Check windscreen washer operation and top up fluid

ü

ü

Check wheel bearings (and report play or noise)

ü

ü

Check tyres for condition and tread

ü

ü

Check and adjust tyre pressures

ü

ü

Refit wheels, adjusting nut torque to manufacturer setting

 

ü

Visually inspect front brakes from inside edge of wheel

ü

 

Visually inspect rear brakes from inside edge of wheel

ü

 

Replace pollen/ charcoal filters as required

 

ü

Replace spark plugs if applicable (please note special or long life plugs subject to extra charge)

 

ü

Replace air filter element (if required – at additional cost)

 

ü

Replace fuel filter (if required – at additional cost)

 

ü

Check tyre wear for visual indication of steering misalignment

ü

ü

Remove rear wheels and check brake discs/drums condition

 

ü

Remove front wheels and check brake discs/drums condition

 

ü

Visually inspect coolant hoses for condition and leaks

ü

ü

Visually inspect expansion bottle leak and cap security

ü

ü

Check cooling fan for operation (where applicable)

ü

ü

Inspect HT leads for visual condition

ü

ü

Inspect distributor cap for visual condition

ü

ü

Inspect rotor arm for visual condition (if applicable)

ü

ü

Check radiator condition and for leaks

ü

ü

Check radiator cap condition

ü

ü

Check throttle linkage and lubricate (if applicable)

ü

ü

Visually inspect smoke emissions (diesel models)

ü

ü

Check for timing/cam belt replacement and report if due

ü

ü

Check for cabin/pollen filter replacement and report if due

ü

ü

Inspect fuel cap for condition and security

ü

ü

Check windscreen condition

ü

ü

Check exterior mirrors for condition

ü

ü

Check interior mirror condition

ü

ü

Check bonnet catch and lubricate (if required)

ü

ü

Inspect and lubricate door hinges (if required)

ü

ü

Check number plates condition and security

ü

ü

Grease steering/suspension and propshaft (if required)

ü

ü

Test brake fluid boiling point (if applicable)

ü

ü

Test starter motor for operation and security

ü

ü

Test alternator for operation and security

 

 

Drain brake system, replace brake fluid and bleed system

 

 

Drain cooling system and replace coolant/antifreeze

 

 

Other as specified by vehicle manufacturer's service schedule

 

 

Complete brake, tyre and emissions report and advisory comments (where applicable)

 

ü

Road test

ü

ü

Vehicle wash & vacuum clean

 

ü

Reset vehicle service light (where applicable)

ü

ü

Stamp service book

ü

ü

 

 

 

 

 

Latest news!  Mer-Tech have now opened a second branch!

Location:

Unit 3/4 Freightliner Road

Brighton Street

Hull

HU3 4UW

 - Call for more details or to book in.

 

 

Feel Free To Call

We Are Here To Help

01482 210053

07900 800024